The short answerIn a typical EP 400/3 4+2 designation, EP identifies a polyester/polyamide textile carcass, 400 is the nominal belt tensile rating in N/mm of width, 3 is the ply count, and 4+2 describes top and bottom rubber covers in millimetres. The code is not a complete conveyor design.
The most expensive misunderstanding in a belt description may be a small slash or plus sign. Carcass rating, fabric layers and cover thickness describe different things. Reading them as one general “strength and thickness” figure makes otherwise clear quotations hard to compare.
Decode one line, field by field
Consider the illustrative specification 800 mm · EP 400/3 · 4+2 mm. This is a reading exercise, not an ABIX stock listing or a released belt design.
| Field | Meaning in this example | Do not infer |
|---|
| 800 mm | Nominal belt width. | The conveyor length or pulley diameter. |
| EP | Polyester warp and polyamide weft textile construction. | A specific cover compound or fire classification. |
| 400 | Nominal total tensile rating: 400 N/mm of width. | 400 N/mm working tension, or 400 per ply. |
| /3 | Three fabric plies. | A total rating of 3 × 400. |
| 4+2 mm | 4 mm top cover and 2 mm bottom cover. | A 6 mm total belt thickness. |
Confirm the designation convention, tolerances and construction in the actual manufacturer’s datasheet.
A complete conveyor belt designation treats carcass rating, ply count and cover thickness as separate characteristics. Record each one explicitly rather than using a strength rating as a substitute for the full construction.
Breaking rating is not working tension
Multiplying rating by width illustrates the scale of the nominal tensile rating. In this example, 400 N/mm × 800 mm = 320,000 N, or 320 kN. That number is not the permissible continuous belt pull on the conveyor.
Working tension requires the design basis, splice efficiency and applicable design factors. Those inputs cannot be recovered by assuming a universal safety factor. The same caution applies when comparing a belt tensile rating with a fastener chart that uses a working-tension rating.
Worked example · illustrativeThree plies versus four plies
Two illustrative offers state EP 400/3 and EP 400/4. Both state the same nominal total rating, while the construction and ply count differ. Neither the slash nor the extra ply supports the conclusion that the second belt has a higher total rating.
The engineering comparison should consider the complete carcass design, flexibility, pulley requirements and splice arrangement. If those properties are unknown, calling the four-ply version “stronger” hides the questions that matter.
Why 4+2 is not total thickness
The covers sit above and below the carcass. Adding their nominal thicknesses gives the combined cover thickness, not the finished belt thickness. The carcass and its surrounding construction remain part of the finished belt.
A thicker top cover may be proposed for an application, but it does not automatically increase the stated carcass rating. Nor does a rating such as EP 400/3 identify abrasion, heat, oil or flame performance. Those properties need their own defined requirement and evidence.
Make a quotation comparison useful
Place the two proposed constructions beside the same fields: width, total rating and units, ply count, cover split, cover grade, total thickness, pulley requirements and splice method. Differences become visible without inventing a single “quality score”.
The designation is a compact map of the belt. Use it to read what the supplier actually offers, then connect that offer to the conveyor design. Its value comes from keeping the fields separate.